View Single Post
  #16  
Old 12-19-2012, 04:28 PM
Andrew Werby Andrew Werby is offline
Level 10 user
 
Join Date: Dec 2005
Location: Oakland, CA
Posts: 647
Re: You don't need to cast them if you don't want

Quote:
Originally Posted by Klat-2 View Post
Thanks. I have a web site and sell bronze there. I am not familiar with the resin.

[There are lots of different kinds of resins: polyester, polyurethane, epoxy, etc.]

Do I still need a mold?

[Yes, unless you want to scan your part and use a rapid prototyping technique to produce a duplicate.]

And can I make a resin from a preexisting mold? They Are made with Poly 72-40 I believe.
[Sure, but the mold release you'd use varies depending on the type of mold and resin. Get advice from the manufacturers of the particular ones you're contemplating, and try a test first, before committing to a major project.]

Andrew Werby
Juxtamorph.com
Reply With Quote